Crystallographic image processing


Crystallographic image processing

Crystallographic image processing (CIP) is a set of methods for determining the atomic structure of crystalline matter from high-resolution electron microscopy (HREM) images obtained in a transmission electron microscope (TEM). The term was created in the research group of Sven Hovmöller at Stockholm University during the early 1980s and became rapidly a label for this approach.


Contents

HREM image contrast and crystal potential reconstruction methods

Many beam HREM images are only directly interpretable in terms of a projected crystal structure if they have been recorded under special conditions, i.e. the so called Scherzer defocus. In that case the positions of the atom columns appear as black blobs in the image. Difficulties for interpretation of HREM images arise for other defocus values because the transfer properties of the objective lens alter the image contrast as function of the defocus. Hence atom columns which appear at one defocus value as dark blobs can turn into white blobs at a different defocus and vice versa. In addition to the objective lens defocus (which can easily be changed by the TEM operator), the thickness of the crystal under investigation has also a significant influence on the image contrast. These two factors often mix and yield HREM images which cannot be straightforwardly interpreted as a projected structure. If the structure is unknown, so that image simulation techniques cannot be applied beforehand, image interpretation is even more complicated. Nowadays two approaches are available to overcome this problem: one method is the exit-wave function reconstruction method, which requires several HREM images from the same area at different defocus and the other method is crystallographic image processing (CIP) which processes only a single HREM image. Exit-wave function reconstruction [1] [2] provides an amplitude and phase image of the (effective) projected crystal potential over the whole field of view. The thereby reconstructed crystal potential is corrected for aberration and delocalisation and also not affected by possible transfer gaps since several images with different defocus are processed. CIP on the other side considers only one image and applies corrections on the averaged image amplitudes and phases. The result of the latter is a pseudo-potential map of one projected unit cell. The result can be further improved by crystal tilt compensation and search for the most likely projected symmetry. In conclusion one can say that the exit-wave function reconstruction method has most advantages for determining the (aperiodic) atomic structure of defects and small clusters and CIP is the method of choice if the periodic structure is in focus of the investigation or when defocus series of HREM images cannot be obtained, e.g. due to beam damage of the sample. However, a recent study on the catalyst related material Cs0.5[Nb2.5W2.5O14] shows the advantages when both methods are linked in one study [3].

Brief history of crystallographic image processing

Aaron Klug suggested in 1979 that a technique that was originally developed for structure determination of membrane protein structures can also be used for structure determination of inorganic crystals [4] [5]. This idea was picked up by the research group of Sven Hovmöller which proved that the metal framework partial structure of the heavy-metal oxide K8-xNb16-xW12+xO80 could be determined from single HREM images recorded at Scherzer defocus [6]. In later years the methods became more sophisticated so that also non-Scherzer images could be processed [7]. One of the most impressive applications at that time was the determination of the complete structure of the complex compound Ti11Se4, which has been inaccessible by X-ray crystallography [8]. Since CIP on single HREM images works only smoothly for layer-structures with at least one short (3 to 5 Å) crystal axis, the method was extended to work also with data from different crystal orientations (= atomic resolution electron tomography). This approach was used in 1990 to reconstruct the 3D structure of the mineral staurolite HFe2Al9Si4O4 [9] [10] and more recently to determine the structures of the huge quasicrystal approximant phase ν-AlCrFe [11] and the structures of the complex zeolites TNU-9 [12] and IM-5 [13].

Crystallographic image processing of high-resolution TEM images

The principal steps for solving a structure of an inorganic crystal from HREM images by CIP are as follows (for a detailed discussion see [14]).

  1. Selecting the area of interest and calculation of the Fourier transform (= power spectrum)
  2. Determining the defocus value and compensating for the contrast changes imposed by the objective lens (done in Fourier space)
  3. Indexing and refining the lattice (done in Fourier space)
  4. Extracting amplitudes and phase values at the refined lattice positions (done in Fourier space)
  5. Determining the origin of the projected unit cell and determining the projected (plane group) symmetry
  6. Imposing constrains of the most likely plane group symmetry on the amplitudes an phases. At this step the image phases are converted into the phases of the structure factors.
  7. Calculating the pseudo-potential map by Fourier synthesis with corrected (structure factor) amplitudes and phases (done in Real space)
  8. Determining 2D (projected) atomic co-ordinates (done in Real space)
Crystallographic Image Processing (CIP) of a high-resolution electron microscopy (HREM) image of α-Ti2Se recorded with a 300 kV TEM (JEOL 3010UHR, point resolution 1.7 Å) along the [001] zone axis. In the first step the Fourier transform of the HREM image is calculated (only the amplitudes are shown). The position of the white ring marks the first crossover of the contrast transfer function (CTF) which is used to determine the defocus value (Δf = -650 Å). The reciprocal lattice is then indexed and amplitudes and phases are extracted. The amplitudes and phases can be used to calculate the averaged image for one unit cell via Fourier synthesis. The pseudo-potential map (p2gg symmetry) for determining 2D atomic co-ordinates was obtained after correction of the phase-shifts imposed by the CTF. The average agreement of atomic co-ordinates determined from the pseudo-potential map and the superimposed model from X-ray diffraction is about 0.2 Å[15].

A few computer programs are available which assist to perform the necessary steps of processing. The most common programs are CRISP [16] [17][18], VEC [19] [20] and the EDM package [21].

Links

CRISP (commercial)

EDM (free for non-commercial purposes) - a ready to go version of EDM is implemented on the elmiX Linux live CD


References

  1. ^ A. Thust, M.H.F. Overwijk, W.M.J. Coene, M. Lentzen (1996) “Numerical correction of lens aberrations in phase retrieval HRTEM” Ultramicroscopy 64, 249 - 264.
  2. ^ L.J. Allen, W. McBride, N.L. O’Leary & M.P. Oxley (2004) “Exit wave reconstruction at atomic resolution” Ultramicroscopy vol. 100, 91-104.
  3. ^ J. Barthel, T.E. Weirich, G. Cox, H. Hibst, A. Thust (2010) “Structure of Cs0.5[Nb2.5W2.5O14] analysed by focal-series reconstruction and crystallographic image processing” Acta Materialia vol. 58, 3764-3772. article
  4. ^ Klug, A. (1979) „Image Analysis and Reconstruction in the Electron Microscopy of Biological Macromolecules“, Chemica Scripta vol. 14, 245-256.
  5. ^ L.A. Amos, R. Henderson, P.N.T. Unwin (1982) “Three-Dimensional Structure Determination by Electron microscopy of Two-Dimensional Crystals” Prog. Biophys. Molec. Biol. vol. 39, 183-231. article
  6. ^ Hovmöller, S., Sjögren, A., Farrants, G., Sundberg, M., Marinder, B.O. (1984) “Accurate atomic positions from electron microscopy”, Nature vol. 311, 238-241. article
  7. ^ X.D. Zou, M. Sundberg, M.Larine, S. Hovmöller (1996) “Structure projection retrieval by image processing of HREM images taken under non optimum defocus conditions” Ultramicroscopy vol. 62, 103-121.article
  8. ^ Weirich, T. E., Ramlau, R., Simon, A., Hovmöller, S., Zou, X. (1996) “A crystal structure determined with 0.02 Å accuracy by electron microscopy”, Nature vol. 382, 144-146. article
  9. ^ Downing, K. H., Meisheng, H., Wenk, H. R., O’Keefe, M. A. (1990) “Resolution of oxygen atoms in staurolite by theee-dimensional transmission electron microscopy”, Nature vol. 348, 525-528. article
  10. ^ Wenk, H. R., Downing, K. H., Meisheng, H., O’Keefe, M. A. (1992) “3D Structure Dertermination from Electron-Microscope Images: Electron Crystallography of Staurolite”, Acta Cryst. vol. A48, 700-716.
  11. ^ Zou, X. D., Mo, Z. M., Hovmöller, S., Li, X. Z., Kuo, K. H. (2003) “Three-dimensional reconstruction of the ν-AlCrFe phase by electron crystallography”, Acta Cryst vol. A59, 526-539. article
  12. ^ F. Gramm, C. Baerlocher, L.B. McCusker, S.J. Warrender, P.A. Wright, B.Han, S.B. Hong, Z. Liu, T. Ohsuna & O. Terasaki (2006) "Complex zeolite structure solved by combining powder diffraction and electron microscopy" Nature 444, 79-81. article
  13. ^ J. Sun, Z. He, S. Hovmöller, X.D. Zou, F. Gramm, C. Baerlocher & L.B. McCusker (2010) "Structure determination of the zeolite IM-5 using electron crystallography" Z. Kristallogr. vol. 225, 77–85. article
  14. ^ X.D. Zou, T.E. Weirich & S. Hovmöller (2001) “Electron Crystallography - Structure determination by combining HREM, crystallographic image processing and electron diffraction.” In: Progress in Transmission Electron Microscopy, I. Concepts and Techniques, X.F. Zhang, Z. Zhang Ed., Springer Series in Surface Science. Vol. 38, Springer 2001, 191 – 222. ISBN 978-3-540-67681-2
  15. ^ T. E. Weirich, From Fourier series towards crystal structures - a survey of conventional methods for solving the phase problem; in: Electron Crystallography - Novel Approaches for Structure Determination of Nanosized Materials, T. E. Weirich, J. L. Lábár, X. Zou, (Eds.), Springer 2006, 235 - 257.
  16. ^ S. Hovmöller (1992) “CRISP: crystallographic image processing on a personal computer” Ultramicroscopy vol. 41, 121–135.
  17. ^ S. Hovmöller, Y.I. Sukharev, A.G. Zharov (1991) “CRISP - A new system for crystallographic image processing on personal computers” Micron and Microscopica Acta vol. 22, 141–142.
  18. ^ H. Zhang, T. Yub, P. Oleynikov, D.Y. Zhao, S. Hovmöller & X.D. Zou (2007) “CRISP and eMap: software for determining 3D pore structures of ordered mesoporous materials by electron crystallography” Studies in Surface Science and Catalysis vol. 165, 109-112.
  19. ^ Z. Wan, Y. Liu, Z. Fu, Y. Li, T. Cheng, F. Li, H. Fan (2003) Visual computing in electron crystallography. Zeitschrift für Kristallographie: Vol. 218, Issue 4 Electron Crystallography, pp. 308-315. doi: 10.1524/zkri.218.4.308.20739
  20. ^ Li Xue-Ming , Li Fang-Hua & Fan Hai-Fu 2009 A revised version of the program VEC (visual computing in electron crystallography) Chinese Phys. vol. B18, 2459. doi: 10.1088/1674-1056/18/6/056
  21. ^ R. Kilaas, L.D. Marks & C.S. Own (2005) “EDM 1.0: Electron direct methods” Ultramicroscopy vol. 102, 233-237.

Further reading

see also the Wiki on Electron Crystallography


Wikimedia Foundation. 2010.

Look at other dictionaries:

  • Crystallographic database — A crystallographic database is a database specifically designed to store information about crystals and crystal structures. Crystals are solids having, in all three dimensions of space, a regularly repeating arrangement of atoms, ions, or… …   Wikipedia

  • Crystallographic defects in diamond — Synthetic diamonds of various colors grown by the high pressure high temperature technique, the diamond size is 2 mm …   Wikipedia

  • Electron crystallography — is a method to determine the arrangement of atoms in solids using a transmission electron microscope (TEM). Contents 1 Comparison with X ray crystallography 2 Radiation damage 3 Protein structures determined by electron crystallography …   Wikipedia

  • Software tools for molecular microscopy — There are a large number of software tools or software applications that have been specifically developed for the field sometimes referred to as molecular microscopy or cryo electron microscopy or cryoEM. Several special issues of the Journal of… …   Wikipedia

  • Raman spectroscopy — Energy level diagram showing the states involved in Raman signal. The line thickness is roughly proportional to the signal strength from the different transitions. Raman spectroscopy (   …   Wikipedia

  • Molecular graphics — (MG) is the discipline and philosophy of studying molecules and their properties through graphical representation.[1] IUPAC limits the definition to representations on a graphical display device .[2] Ever since Dalton s atoms and Kekulé s benzene …   Wikipedia

  • X-ray crystallography — can locate every atom in a zeolite, an aluminosilicate with many important applications, such as water purification. X ray crystallography is a method of determining the arrangement of atoms within a crystal, in which a beam of X rays strikes a… …   Wikipedia

  • Dislocation — For the syntactic operation, see Dislocation (syntax). For the medical term, see Joint dislocation. In materials science, a dislocation is a crystallographic defect, or irregularity, within a crystal structure. The presence of dislocations… …   Wikipedia

  • Electron backscatter diffraction — An electron backscatter diffraction pattern An electron backscatter diffraction pattern of monocrystalline silicon, taken …   Wikipedia

  • Diffraction topography — (short: topography ) is an X ray imaging technique based on Bragg diffraction. Diffraction topographic images ( topographs ) record the intensity profile of a beam of X rays (or, sometimes, neutrons) diffracted by a crystal. A topograph thus… …   Wikipedia


Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”

We are using cookies for the best presentation of our site. Continuing to use this site, you agree with this.