Di-(2-ethylhexyl)phosphoric acid

Di-(2-ethylhexyl)phosphoric acid
Di-(2-ethylhexyl)phosphoric acid
Di(2-ethylhexyl)phosphoric acid
Identifiers
CAS number 298-07-7
Properties
Molecular formula C16H35O4P
Molar mass 322.43 g/mol
Appearance odorless yellow liquid
Density 0.9758 g/mL
Melting point

-50°C

Boiling point

393°C

 YesY acid (verify) (what is: YesY/N?)
Except where noted otherwise, data are given for materials in their standard state (at 25 °C, 100 kPa)
Infobox references

Di-(2-ethylhexyl)phosphoric acid (DEHPA or HDEHP) is an organophosphorus compound with the formula (C8H17O)2PO2H. The yellow liquid is a diester of phosphoric acid and 2-ethylhexanol. It is used in the solvent extraction of uranium as well as the rare earth metals.[1]

Contents

Preparation

DEHPA is prepared through the reaction of phosphorus pentoxide and 2-ethylhexanol:

4 C8H17OH + P4O10 → 2 [(C8H17O)PO(OH)]2O
[(C8H17O)PO(OH)]2O + C8H17OH → (C8H17O)2PO(OH) + (C8H17O)PO(OH)2

These reaction produce a mixture of mono-, di-, and trisubstituted phosphates, from which DEHPA can be isolated based on solubility.[2]

Use in uranium extraction

Extraction

DEHPA is used in the solvent extraction of uranium salts from solutions containing the sulfate, chloride, or perchlorate anions. This extraction is known as the “Dapex procedure.” Reminiscent of the behaviors of carboxylic acids, DEHPA generally exists as a hydrogen-bonded dimer in the non-polar organic solvents. For practical applications, the solvent, often called a diluents, is typically kerosene.[3] A complex is formed from two equivalents of the conjugate base of DEHPA and one uranyl ion.[4] Complexes of the formula (UO2)2[(O2P(OR)2]4 also form, and at high concentrations of uranium, polymeric complexes may form.[3]

The extractability of Fe3+ is similar to that of uranium, so it must be reduced to Fe2+ before the extraction.[3]

Stripping

The uranium is then stripped from the DEHPA/kerosene solution with hydrochloric acid, hydrofluoric acid, or carbonate solutions. Sodium carbonate solutions effectively strip uranium from the organic layer, but the sodium salt of DEHPA is somewhat soluble in water, which can lead to loss of the extractant.[2]

Synergistic effects

The extractive capabilities of DEHPA can be increased through synergistic effects by the addition of other organophosphorus compounds. Tributyl phosphate is often used, as well as dibutyl-, diamyl-, and dihexylphosphonates. The synergistic effects are thought to occur by the addition of the trialkylphosphate to the uranyl-DEHPA complex by hydrogen bonding. The synergistic additive may also react with the DEHPA, competing with the uranyl extraction, resulting in a decrease in extraction efficiency past a concentration specific to the compound. [5]

Alternatives to DEHPA

Secondary, tertiary, and quaternary amines have also been used for some uranium extractions as an alternative to DEHPA. Compared to phosphate extractants, amines are more selective for uranium, extract the uranium faster, and are easily stripped with a wider variety of reagents. However, the phosphates are more tolerant of solids in the feed solution and show faster phase separation.[5]

References

  1. ^ Sato, T. Hydrometallurgy, 1989, volume 22, 121-140. doi:10.1016/0304-386X(89)90045-5
  2. ^ a b Galkin, N.P.; Sudarikov, B.N.; Veryatin, U.D.; Shishkov, Yu.D.; Maiorov, A.A. Technology of Uranium, 1st Ed.; Israel Program for Scientific Translations: Jerusalem, 1966.
  3. ^ a b c Wilkinson, W.D. Uranium Metallurgy, 1st Ed.; Interscience Publishers: New York, 1962; Vol. 1.
  4. ^ Lemire, A.E.; Janzen, A.F.; Marat, K. A 31P and 15N Study of the Extraction of Uranyl Nitrate by Di-2-ethylhexyl Phosphoric Acid. Inorg. Chim. Acta, 1985, 110, 234-241. doi:10.1016/S0020-1693(00)82312
  5. ^ a b Merritt, R.C. The Extractive Metallurgy of Uranium, 1st Ed.; Colorado School of Mines Research Institution, 1971.

Wikimedia Foundation. 2010.

Игры ⚽ Нужен реферат?

Look at other dictionaries:

  • uranium processing — Introduction       preparation of the ore for use in various products.       Uranium (U), although very dense (19.1 grams per cubic centimetre), is a relatively weak, nonrefractory metal. Indeed, the metallic properties of uranium appear to be… …   Universalium

  • Mendelevium — fermium ← mendelevium → nobelium Tm ↑ Md ↓ (Upu) …   Wikipedia

  • National pollutant inventory — or NPI is an Australian pollution database of emissions managed by the Australian Government on behalf of the Australian States and Territories. The NPI was created based on the UK model and was agreed to by the Keating labor government in order… …   Wikipedia

  • National Pollutant Inventory — or NPI is an Australian pollution database of emissions managed by the Australian Government on behalf of the Australian States and Territories. The NPI was created based on the UK model and was agreed to by the Keating labor government in order… …   Wikipedia

  • Zinc oxide — Other names Zinc white Calamine Identifiers …   Wikipedia

  • List of EC numbers (EC 3) — This list contains a list of EC numbers for the third group, EC 3, hydrolases, placed in numerical order as determined by the Nomenclature Committee of the International Union of Biochemistry and Molecular Biology.EC 3.1: Acting on Ester BondsEC… …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”