Diffusion capacity

Diffusion capacity
Diffusion capacity
Diagnostics
MeSH D011653

In biology, diffusion capacity is a measurement of the lung's ability to transfer gases. Oxygen uptake may be limited by diffusion in circumstances of low ambient oxygen or high pulmonary blood flow. Carbon dioxide is not limited by diffusion under most circumstances.

The "diffusing capacity" or "diffusion capacity" is part of a comprehensive test series of lung function called pulmonary function testing. In Europe, this is often called the "transfer factor". Critics of the term "diffusion capacity" argue that it may be misleading, and point out two problems with the term. The first is that the test measures not just diffusion across the alveolar-capillary membrane, but also takes into account factors affecting the chemical combination of a given gas with hemoglobin. The second criticism is that the test is typically measured under submaximal conditions and doesn't truly reflect a functional capacity. For these reasons the term "transfer factor" better reflects the physiological process being measured.

Contents

Calculation

The rate of flow is directly proportional to the oxygen gradient (per Fick's law of diffusion), and the diffusion capacity (DLOO2) can be calculated as the ratio of oxygen flux (J^*) across the alveolar-capillary membrane over the oxygen partial pressure gradient between the alveoli ("A") and the alveolar capillaries ("a")

D_L = \frac {J^*_{O2}}{P_{AO2} - P_{aO2}}

(The asterisk should be read as a dot over the letter, which is used to denote rate in respiratory physiology.)

J*O2 is the uptake of oxygen (ml/min). PAO2 is the alveolar partial pressure of oxygen. PaO2 is the partial pressure of oxygen in the alveolar capillary. Thus, the higher the diffusing capacity DL, the more gas will be transferred across the alveolar-capillary membrane for a given gradient in partial pressure (or concentration) of the gas.

Because it is difficult to measure the capillary partial pressure of oxygen, carbon monoxide (CO) is used as the test gas to measure the diffusing capacity (Dlco). Because CO is so tightly bound to hemoglobin in the red blood cells, the partial pressure of CO in the capillaries is assumed to be zero. Thus,

D_LCO = \frac {J^*_{CO}}{P_{ACO}}

Test Performance

In practice, the test is performed by having the test subject blow out all of the air that they can to reach residual volume. The person then takes a full vital capacity inhalation of a test gas mixture that contains a small amount of carbon monoxide (usually 0.3%) and some helium or other non-absorbed tracer gas. The test gas is held in the lung for about 10 seconds and then is exhaled from the lung. The first part of the expired gas is discarded and the next portion which represents gas from the alveoli is collected. By analyzing the concentrations of carbon monoxide and helium in the inspired gas and in the exhaled gas, it is possible to calculate how much carbon monoxide was taken up during the breath hold, and what the partial pressure of carbon monoxide was during the breath hold. This method is known as the single-breath diffusing capacity test.

Other methods that are not so widely used at present can measure the diffusing capacity. These include the steady state diffusing capacity that is performed during regular tidal breathing, or the rebreathing method that requires rebreathing from a reservoir of gas mixtures. A more sophisticated "three-equation method" which involves fast responding analysers for the carbon monoxide and a tracer gas such as helium has been developed. It monitors all parameters continuously and solves some of the technical problems of the traditional method but is more expensive to implement.

Interpretation

Values between 75% and 125% of average diffusion capacity in the healthy population are considered normal.[1]

The diffusing capacity (DLCO) is a test of the integrity of the alveolar-capillary surface area for gas transfer. It may be reduced in disorders that damage the alveolar walls (septa) such as emphysema, which leads to a loss of effective surface area. The DLCO is also reduced in disorders that thicken or damage the alveolar walls such as pulmonary fibrosis. The DLCO is also reduced in interstitial lung diseases such as hypersensitivity pneumonitis (e.g. bird fancier's lung, farmer's lung) or dust-inhalation diseases such as asbestosis. Because the transfer of CO depends upon how much blood is present in the lung capillaries, the DLCO can be reduced due to anemia and raised in polycythemia. Some laboratories adjust or correct the DLCO for a serum hemoglobin to take into account the effect of anemia. Disorders of the pulmonary blood vessels such as chronic thromboembolic disease or pulmonary hypertension also reduce the diffusing capacity, as can any condition/disease which results in reduction in pulmonary capillary blood volume. The DLCO is not, however, a sensitive test for acute pulmonary embolism. Cigarette smokers tend to have lower DLCO, which is partly due to damage to the lungs (mild emphysema) and partly due to the retention of carbon monoxide from the cigarettes, which causes back pressure (decreasing the CO gradient). For these reasons, the DLCO is a sensitive test for disorders of the lung, but does not point toward a specific diagnosis. By calculating the dilution of the tracer gas, the test can also be used to estimate the total lung capacity. In the presence of poor gas mixing from obstructive lung disease it is used to measure the single breath total lung capacity.

References

  1. ^ LUNGFUNKTION - Practice compendium for semester 6. Department of Medical Sciences, Clinical Physiology, Academic Hospital, Uppsala, Sweden. Retrieved 2010.

External links


Wikimedia Foundation. 2010.

Игры ⚽ Нужен реферат?

Look at other dictionaries:

  • Capacity — is the ability to hold, receive or absorb, or a measure thereof, similar to the concept of volume.Capacity may also refer to: *Capacity (economics), the point of production at which a firm or industry s average (or per unit ) costs begin to rise …   Wikipedia

  • Diffusion of technology in Canada — This article outlines the history of the diffusion or spread of technology in Canada. Technologies chosen for treatment here include, in rough order, transportation, communication, energy, materials, industry, public works, public services… …   Wikipedia

  • diffusing capacity — diffusion capacity the ability of the alveolocapillary membrane to transfer gas: a reflection of the thinness and area of the alveolocapillary membrane. It is the amount of gas transferred per minute from the alveolar gas to the pulmonary… …   Medical dictionary

  • Closing capacity — The closing capacity (CC) is the volume in the lungs at which its smallest airways, the alveoli collapse. The alveoli lack supporting cartilage and so depend on other factors to keep them open. The closing capacity is greater than the residual… …   Wikipedia

  • Spirometry — TLC Total lung capacity: the volume in the lungs at maximal inflation RV Residual volume: the volume of air remaining in the lungs …   Wikipedia

  • VO2 max — VO2 redirects here. For the chemical compound, see Vanadium(IV) oxide. VO2 max (also maximal oxygen consumption, maximal oxygen uptake, peak oxygen uptake or aerobic capacity) is the maximum capacity of an individual s body to transport and use… …   Wikipedia

  • Oxygen–haemoglobin dissociation curve — The oxygen–haemoglobin dissociation curve (or oxygen–hemoglobin dissociation curve) plots the proportion of haemoglobin in its saturated form on the vertical axis against the prevailing oxygen tension on the horizontal axis. The oxyhaemoglobin… …   Wikipedia

  • DLCO — (Diffusing capacity of the lung for carbon monoxide,[1]) is the extent to which oxygen passes from the air sacs of the lungs into the blood. Commonly, it refers to the test used to determine this parameter. It was introduced in 1909.[2] Contents… …   Wikipedia

  • Respiratory system — See also: Respiratory tract Respiratory A complete, schematic view of the human respiratory system with their parts and functions. Latin …   Wikipedia

  • Hypoxia (medical) — Hypoxia ICD 9 799.02 MeSH D000860 Hypoxia, or hypoxiation, is a pathological condition in which the body as a whole (generalized hypoxia) or a region of the body (tissue hypoxia) is deprived of adequate ox …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”