Pressurised heavy water reactor

Pressurised heavy water reactor

A pressurised heavy water reactor (PHWR) is a nuclear power reactor, commonly using unenriched natural uranium as its fuel, that uses heavy water (deuterium oxide D2O) as its coolant and moderator. The heavy water coolant is kept under pressure in order to raise its boiling point, allowing it to be heated to higher temperatures without boiling, much as in a PWR. While heavy water is significantly more expensive than ordinary light water, it yields greatly enhanced neutron economy, allowing the reactor to operate without fuel enrichment facilities (mitigating the additional capital cost of the heavy water) and generally enhancing the ability of the reactor to efficiently make use of alternate fuel cycles.

The reactors are used in nuclear power plants to produce nuclear power from nuclear fuel.

History

The first commercial PHWRs were of the Canadian CANDU design built by AECL. Marketed world-wide, 29 are in currently in use as of 2008. The Nuclear Power Corporation of India Limited (NPCIL) has built and operates 13 PHWR units. Initially these indigenously built reactors were reverse-engineered from the CANDU design, but later models have diverged significantly. Siemens has also offered a PHWR design in the past, completing one unit in Argentina and partially completing a second, larger version at the same site.

Purpose of using heavy water

"See nuclear reactor physics, nuclear fission and heavy water. The key to maintaining a nuclear reaction within a nuclear reactor is to use the neutrons being released during fission to stimulate fission in other nuclei. With careful control over the geometry and reaction rates, this can lead to a self-sustaining chain reaction, a state known as "criticality". Natural uranium consists of a mixture of various isotopes, primarily 238U and a much smaller amount (about 0.72% by weight) of 235U. 238U can only be fissioned by neutrons that are fairly energetic, about 1 MeV or above. No amount of 238U can be made "critical", however, since it will tend to parasitically absorb more neutrons than it releases by the fission process. 235U, on the other hand, can support a self-sustained chain reaction, but due to the low natural abundance of 235U, natural uranium cannot achieve criticality by itself. The "trick" to making a working reactor is to slow some of the neutrons to the point where their probability of causing nuclear fission in 235U increases to a level that permits a sustained chain reaction in the uranium as a whole. This requires the use of a neutron moderator, which absorbs some of the neutrons' kinetic energy, slowing them down to an energy comparable to the thermal energy of the moderator nuclei themselves (leading to the terminology of "thermal neutrons" and "thermal reactors"). During this slowing-down process it is beneficial to physically separate the neutrons from the uranium, since 238U nuclei have an enormous parasitic affinity for neutrons in this intermediate energy range (a reaction known as "resonance" absorption). This is a fundamental reason for designing reactors with discrete solid fuel separated by moderator, rather than employing a more homogeneous mixture of the two materials. Water makes an excellent moderator; the hydrogen atoms in the water molecules are very close in mass to a single neutron, and thus have a potential for high energy transfer, similar conceptually to the collision of two billiard balls. However, in addition to being a good moderator, water is also fairly effective at absorbing neutrons. Using water as a moderator will absorb enough neutrons that there will be too few left over to react with the small amount of 235U in the fuel, again precluding criticality in natural uranium. Instead, light water reactors first enhance the amount of 235U in the uranium, producing enriched uranium, which generally contains between 3% and 5% 235U by weight (the waste from this process is known as depleted uranium, consisting primarily of 238U). In this enriched form there "is" enough 235U to react with the water-moderated neutrons to maintain criticality. One complication of this approach is the requirement to build an uranium enrichment facility, which are generally expensive to build and operate. They also present a nuclear proliferation concern; the same systems used to enrich the 235U can also be used to produce much more "pure" weapons-grade material (90% or more 235U), suitable for producing a nuclear bomb. This is not a trivial exercise, by any means, but feasible enough that enrichment facilities present a significant nuclear proliferation risk. An alternative solution to the problem is to use a moderator that does "not" absorb neutrons as readily as water. In this case potentially all of the neutrons being released can be moderated and used in reactions with the 235U, in which case there "is" enough 235U in natural uranium to sustain criticality. One such moderator is heavy water, or deuterium-oxide. Although it reacts dynamically with the neutrons in a similar fashion to light water (albeit with less energy transfer on average, given that heavy hydrogen, or deuterium, is about twice the mass of hydrogen), it already has the extra neutron that light water would normally tend to absorb.

Advantages and Disadvantages

The use of heavy water moderator is the key to the PHWR system, enabling the use of natural uranium as fuel (in the form of ceramic UO2), which means that it can be operated without expensive uranium enrichment facilities. Additionally, the mechanical arrangement of the PHWR, which places most of the moderator at lower temperatures, is particularly efficient because the resulting thermal neutrons are "more thermal" than in traditional designs, where the moderator normally runs hot. This means that a PHWR is not only able to "burn" natural uranium and other fuels, but tends to do so more effeciently as well.

Pressurised heavy water reactors do have some drawbacks. Heavy water generally costs hundreds of dollars per kilogram, though this is a tradeoff against reduced fuel costs. It is also notable that the reduced energy content of natural uranium as compared to enriched uranium necessitates more frequent replacement of fuel; this is normally accomplished by use of an on-power refuelling system. The increased rate of fuel movement through the reactor also results in higher volumes of spent fuel than in reactors employing enriched uranium; however, as the unenriched fuel was less reactive, the heat generated is less, allowing the spent fuel to be stored much more compactly. [ [http://books.nap.edu/openbook.php?record_id=11320&page=50 High-level waste repository development for LWR and PHWR spent fuel] ]

References

* [http://www.cised.org/EconomicsofNuclearPowerfromHeavyWaterReactors.pdf Economics of Nuclear Power from Heavy Water Reactors]
* [http://www.dae.gov.in/publ/ar0203/chap1.pdf Nuclear Power Program - Stage1 - Pressurised Heavy Water Reactor]

ee also

*CANDU
*List of nuclear reactors
*Heavy water reactor
*Pressurized water reactor
* [http://www.aecl.ca/ Official website of AECL]


Wikimedia Foundation. 2010.

Игры ⚽ Нужен реферат?

Look at other dictionaries:

  • Heavy water reactor — Heavy water reactors use heavy water as a neutron moderator. Heavy water is deuterium oxide, D2O. Neutrons in a nuclear reactor that uses uranium must be slowed down so that they are more likely to split other atoms and get more neutrons released …   Wikipedia

  • Advanced Heavy Water Reactor — The Advanced Heavy Water Reactor (AHWR) is the latest Indian design for a next generation nuclear reactor that will burn Thorium in its fuel core. It is slated to form the third stage in India s 3 stage fuel cycle plan.… …   Wikipedia

  • CANDU reactor — The CANDU reactor is a Canadian invented, pressurized heavy water reactor developed initially in the late 1950s and 1960s by a partnership between Atomic Energy of Canada Limited (AECL), the Hydro Electric Power Commission of Ontario (now known… …   Wikipedia

  • Fast breeder reactor — The fast breeder or fast breeder reactor (FBR) is a fast neutron reactor designed to breed fuel by producing more fissile material than it consumes. The FBR is one possible type of breeder reactor. The reactors are used in nuclear power plants to …   Wikipedia

  • Advanced CANDU Reactor — The Advanced CANDU Reactor (ACR) is a Generation III+ design and is a further development of existing CANDU reactors designed by Atomic Energy of Canada Limited. It is a light water cooled reactor that incorporates features of both Pressurised… …   Wikipedia

  • Doosan Heavy Industries & Construction — Type Public (traded on the Korea Stock Exchange) Industry Power plants Construction Founded …   Wikipedia

  • Nuclear reactor — Core of CROCUS, a small nuclear reactor used for research at the EPFL in Switzerland This article is a subarticle of Nuclear power. A nuclear reactor is a device to initiate and control a sustained nuclear chain reaction. Most commonly they are… …   Wikipedia

  • Nuclear reactor technology — This article is a subarticle of Nuclear power .A nuclear reactor is a device in which nuclear chain reactions are initiated, controlled, and sustained at a steady rate, as opposed to a nuclear bomb, in which the chain reaction occurs in a… …   Wikipedia

  • Breeder reactor — Assembly of the core of Experimental Breeder Reactor I in Idaho, 1951 A breeder reactor is a nuclear reactor that generates more fissile material in fuel than it consumes.[1] These reactors are considered appealing due to their superior fuel… …   Wikipedia

  • Anexo:Reactores nucleares — Contenido 1 África 1.1 Argelia 1.2 Egipto 1.3 Marruecos 1.4 …   Wikipedia Español

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”