Time division multiple access

Time division multiple access
This article is about the channel access method. The name "TDMA" is also commonly used in the United States to refer to Digital AMPS, which is an obsolete mobile telephone standard that uses TDMA to control channel access.

Time division multiple access (TDMA) is a channel access method for shared medium networks. It allows several users to share the same frequency channel by dividing the signal into different time slots. The users transmit in rapid succession, one after the other, each using its own time slot. This allows multiple stations to share the same transmission medium (e.g. radio frequency channel) while using only a part of its channel capacity. TDMA is used in the digital 2G cellular systems such as Global System for Mobile Communications (GSM), IS-136, Personal Digital Cellular (PDC) and iDEN, and in the Digital Enhanced Cordless Telecommunications (DECT) standard for portable phones. It is also used extensively in satellite systems, combat-net radio systems, and PON networks for upstream traffic from premises to the operator. For usage of Dynamic TDMA packet mode communication, see below.

TDMA frame structure showing a data stream divided into frames and those frames divided into time slots.

TDMA is a type of Time-division multiplexing, with the special point that instead of having one transmitter connected to one receiver, there are multiple transmitters. In the case of the uplink from a mobile phone to a base station this becomes particularly difficult because the mobile phone can move around and vary the timing advance required to make its transmission match the gap in transmission from its peers.

Contents

TDMA characteristics

  • Shares single carrier frequency with multiple users
  • Non-continuous transmission makes handoff simpler
  • Slots can be assigned on demand in dynamic TDMA
  • Less stringent power control than CDMA due to reduced intra cell interference
  • Higher synchronization overhead than CDMA
  • Advanced equalization may be necessary for high data rates if the channel is "frequency selective" and creates Intersymbol interference
  • Cell breathing (borrowing resources from adjacent cells) is more complicated than in CDMA
  • Frequency/slot allocation complexity
  • Pulsating power envelope: Interference with other devices

TDMA in mobile phone systems

2G systems

Most 2G cellular systems, with the notable exception of IS-95, are based on TDMA. GSM, D-AMPS, PDC, iDEN, and PHS are examples of TDMA cellular systems. GSM combines TDMA with Frequency Hopping and wideband transmission to minimize common types of interference.

In the GSM system, the synchronization of the mobile phones is achieved by sending timing advance commands from the base station which instructs the mobile phone to transmit earlier and by how much. This compensates for the propagation delay resulting from the light speed velocity of radio waves. The mobile phone is not allowed to transmit for its entire time slot, but there is a guard interval at the end of each time slot. As the transmission moves into the guard period, the mobile network adjusts the timing advance to synchronize the transmission.

Initial synchronization of a phone requires even more care. Before a mobile transmits there is no way to actually know the offset required. For this reason, an entire time slot has to be dedicated to mobiles attempting to contact the network (known as the RACH in GSM). The mobile attempts to broadcast at the beginning of the time slot, as received from the network. If the mobile is located next to the base station, there will be no time delay and this will succeed. If, however, the mobile phone is at just less than 35 km from the base station, the time delay will mean the mobile's broadcast arrives at the very end of the time slot. In that case, the mobile will be instructed to broadcast its messages starting nearly a whole time slot earlier than would be expected otherwise. Finally, if the mobile is beyond the 35 km cell range in GSM, then the RACH will arrive in a neighbouring time slot and be ignored. It is this feature, rather than limitations of power, that limits the range of a GSM cell to 35 km when no special extension techniques are used. By changing the synchronization between the uplink and downlink at the base station, however, this limitation can be overcome.

3G systems

Although most major 3G systems are primarily based upon CDMA[citation needed], time division duplexing (TDD), packet scheduling (dynamic TDMA) and packet oriented multiple access schemes are available in 3G form, combined with CDMA to take advantage of the benefits of both technologies.

While the most popular form of the UMTS 3G system uses CDMA and frequency division duplexing (FDD) instead of TDMA, TDMA is combined with CDMA and Time Division Duplexing in two standard UMTS UTRA

TDMA in wired networks

The ITU-T G.hn standard, which provides high-speed local area networking over existing home wiring (power lines, phone lines and coaxial cables) is based on a TDMA scheme. In G.hn, a "master" device allocates "Contention-Free Transmission Opportunities" (CFTXOP) to other "slave" devices in the network. Only one device can use a CFTXOP at a time, thus avoiding collisions. FlexRay protocol which is also a wired network used for Safety Critical communication in modern cars, uses the TDMA method for data transmission control.

Comparison with other multiple-access schemes

In radio systems, TDMA is usually used alongside Frequency-division multiple access (FDMA) and Frequency division duplex (FDD); the combination is referred to as FDMA/TDMA/FDD. This is the case in both GSM and IS-136 for example. Exceptions to this include the DECT and PHS micro-cellular systems, UMTS-TDD UMTS variant, and China's TD-SCDMA, which use Time Division duplexing, where different time slots are allocated for the base station and handsets on the same frequency.

A major advantage of TDMA is that the radio part of the mobile only needs to listen and broadcast for its own time slot. For the rest of the time, the mobile can carry out measurements on the network, detecting surrounding transmitters on different frequencies. This allows safe inter frequency handovers, something which is difficult in CDMA systems, not supported at all in IS-95 and supported through complex system additions in Universal Mobile Telecommunications System (UMTS). This in turn allows for co-existence of microcell layers with macrocell layers.

CDMA, by comparison, supports "soft hand-off" which allows a mobile phone to be in communication with up to 6 base stations simultaneously, a type of "same-frequency handover". The incoming packets are compared for quality, and the best one is selected. CDMA's "cell breathing" characteristic, where a terminal on the boundary of two congested cells will be unable to receive a clear signal, can often negate this advantage during peak periods.

A disadvantage of TDMA systems is that they create interference at a frequency which is directly connected to the time slot length. This is the buzz which can sometimes be heard if a TDMA phone is left next to a radio or speakers.[1] Another disadvantage is that the "dead time" between time slots limits the potential bandwidth of a TDMA channel. These are implemented in part because of the difficulty in ensuring that different terminals transmit at exactly the times required. Handsets that are moving will need to constantly adjust their timings to ensure their transmission is received at precisely the right time, because as they move further from the base station, their signal will take longer to arrive. This also means that the major TDMA systems have hard limits on cell sizes in terms of range, though in practice the power levels required to receive and transmit over distances greater than the supported range would be mostly impractical anyway.

Dynamic TDMA

In dynamic time division multiple access, a scheduling algorithm dynamically reserves a variable number of time slots in each frame to variable bit-rate data streams, based on the traffic demand of each data stream. Dynamic TDMA is used in

  • AirSync Ubiquiti AirMax AirSync
  • HIPERLAN/2 broadband radio access network.
  • IEEE 802.16a WiMax
  • Bluetooth
  • The Packet radio multiple access (PRMA) method for combined circuit switched voice communication and packet data.
  • TD-SCDMA
  • ITU-T G.hn

See also

References


Wikimedia Foundation. 2010.

Игры ⚽ Нужна курсовая?

Look at other dictionaries:

  • Time Division Multiple Access — Multiplexverfahren (lat. multiplex „vielfach, vielfältig“) sind Methoden zur Signal und Nachrichtenübertragung, bei denen mehrere Signale zusammengefasst (gebündelt) und simultan über ein Medium (Leitung, Kabel oder Funkstrecke) übertragen werden …   Deutsch Wikipedia

  • Time division multiple access — Accès multiple à répartition dans le temps Le Time division multiple access (TDMA) est un mode de multiplexage permettant de transmettre plusieurs signaux sur un seul canal. Il s’agit du multiplexage temporel, dont le principe est de découper le… …   Wikipédia en Français

  • time division multiple access — daugkartinė laikinio tankinimo kreiptis statusas T sritis radioelektronika atitikmenys: angl. time division multiple access vok. Zeitmultiplexzugriff, m rus. многократный доступ с временным уплотнением, m pranc. accès multiple par répartition… …   Radioelektronikos terminų žodynas

  • Time Division Multiple Access —    Abbreviated TDMA. A technique used to allocate multiple channels on the same frequency on a cellular phone or satellite communications system.    See also Code Division Multiple Access …   Dictionary of networking

  • Multi-frequency time division multiple access — MF TDMA (Multi Frequency, Time Division Multiple Access) is the leading technology for dynamically sharing bandwidth resources in an over the air, two way communications network. Many variations of MF TDMA technology (including simple TDMA) exist …   Wikipedia

  • Self-Organized Time Division Multiple Access — The Self Organized Time Division Multiple Access (STDMA) channel access method is based on an invention by Håkan Lans.The system has been declared as the world standard for both marine and aviation by the United Nations (IMO ICAO) thus… …   Wikipedia

  • Time division Multiple Access — method of cellular communications which allows alternating transmission on one channel by dividing time into slices and giving one slice to every transmission, TDMA …   English contemporary dictionary

  • time division multiple access —    (TDMA)    Satellite communication technique that combines many conversations to provide concurrent conversations onto one transponder. TDMA separates a radio frequency and then assigns every sixth signal to a particular telephone conversation …   IT glossary of terms, acronyms and abbreviations

  • Time Division Synchronous Code Division Multiple Access — (ou TD SCDMA) est une technique de transmission pour téléphone mobile dite de troisième génération (3G). Elle est censée concurrencer les normes déjà bien installées dans le monde de la téléphonie mobile telles que l UMTS ou le CDMA 2000. Forte… …   Wikipédia en Français

  • Code division multiple access — This article is about a channel access method. For the mobile phone technology referred to as CDMA, see IS 95 and CDMA2000. Multiplex techniques Circuit mode (constant bandwidth) TDM · FDM  …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”