Derived unique key per transaction

Derived unique key per transaction

In cryptography, Derived Unique Key Per Transaction (DUKPT) is a key management scheme in which for every transaction, a unique key is used which is derived from a fixed key. Therefore, if a derived key is compromised, future and past transaction data are still protected since the next or prior keys cannot be determined easily. DUKPT is specified in ANSI X9.24 part 1.

DUKPT allows the processing of the encryption to be moved away from the devices that hold the shared secret. The encryption is done with a derived key, which is not re-used after the transaction. DUKPT is used to encrypt electronic commerce transactions. While it can be used to protect information between two companies or banks, it is typically used to encrypt PIN information acquired by Point-Of-Sale (POS) devices.

DUKPT is not itself an encryption standard; rather it is a key management technique. The features of the DUKPT scheme are:

  • enable both originating and receiving parties to be in agreement as to the key being used for a given transaction,
  • each transaction will have a distinct key from all other transactions, except by coincidence,
  • if a present key is compromised, past and future keys (and thus the transactional data encrypted under them) remain uncompromised,
  • each device generates a different key sequence,
  • originators and receivers of encrypted messages do not have to perform an interactive key-agreement protocol beforehand.

Contents

Overview

DUKPT was first invented in the late 1980s at Visa, but it didn’t receive much acceptance until the 1990s. It was during this later period that the industry practices shifted towards recommending (and later requiring) that each device have a distinct encryption key. The scheme that was state-of-the-art at the time—known as “Master/Session”—would require that every PIN encrypting device be initialized with a unique master key. In consequence, processors would require a table of encryption keys as large as the number of devices deployed, when handling transactions originating from devices using Master/Session key management, given the need for unique keys per device. This table could become quite large for a major merchant acquirer. DUKPT solves this problem because—although each device is still initialized with a distinct key—this device initialization key is derived from a different key which an entire family of devices may share. Hence, the recipient of encrypted messages needs only to store one key to support a large number of devices in the field, while simultaneously meeting the unique-key-per-device requirement.

This single key was called the “super-secret key” in the original description of the algorithm, but was later renamed to the more official-sounding “Base Derivation Key” (or BDK). The original name perhaps conveys better the true nature of this key, because if it is compromised then all devices and all transactions are similarly compromised. This is mitigated by the fact that there are only two parties that know the BDK: the recipient of the encrypted messages (typically a merchant acquirer), and the party which initializes the encryption devices (typically the manufacturer of the device). Further, there are pains taken to ensure that this key does not exist in plaintext outside of any tamper-resistant security module (TRSM, or HSM), and in fact is not the key that is used to initialize the encryption device that will participate in DUKPT operations. Rather, a different key is irreversibly derived from the BDK (and within a TRSM), known as the “Initial PIN Encryption Key” (IPEK). This is the key that is actually injected into the device, and a compromise of that key will not compromise the BDK (though the device itself would be considered compromised, and will need to have a new key injected). Even then, the IPEK is used internally by the device to create yet another set of keys irreversibly derived from it (called the “Future Keys”), and the IPEK is then immediately discarded.

On the originating (encrypting) end, the system works as follows:

  1. A transaction is initiated which involves data to be encrypted. The typical case is a customer's PIN.
  2. A key is retrieved from the set of “Future Keys”, that is used to encrypt the message, creating a cryptogram.
  3. The pair of the cryptogram and an identifier known as the “Key Serial Number” (KSN) is returned from the encrypting device. The KSN is formed from the device’s unique identifier, and an internal transaction counter.
  4. The (cryptogram, KSN) pair is forwarded on to the intended recipient, typically the merchant acquirer, where it is decrypted and processed further.
  5. Internally, the device increments the transaction counter, invalidates the key just used, and possibly generates more future keys if needed.

On the receiving (decrypting) end, the system works as follows:

  1. The (cryptogram, KSN) pair are received.
  2. The appropriate BDK (if the system has more than one) is located.
  3. The receiving system first regenerates the IPEK, and then goes through a process similar to that used on the originating system to arrive at the same encrypting key that was used (the session key). The Key Serial Number (KSN) provides the information needed to do this.
  4. The cryptogram is decrypted with session key.
  5. Any further processing is done. For merchant acquirers, this usually means encrypting under another key to forward on to a switch (doing a “translate”), but for certain closed-loop operations may involve directly processing the data, such as verifying the PIN.

The method for arriving at session keys is somewhat different on the originating side as it is on the receiving side. On the originating side, there is considerable state information retained between transactions, including a transaction counter, a serial number, and an array of up to 21 “Future Keys”. On the receiving side there is no state information retained; only the BDK is persistent across processing operations. This arrangement provides convenience to the receiver (a large number of devices may be serviced while only storing one key). It also provides some additional security with respect to the originator (PIN capture devices are often deployed in security-averse environments; the security parameters in the devices are ‘distant’ from the sensitive BDK, and if the device is compromised, other devices are not implicitly compromised).

Registers Usage

Backup Registers

The following storage areas relating to key management are maintained from the time of the "Load Initial Key" command for the life of the PIN Entry Device:

Initial Key Serial Number Register (59 bits)

Holds the left-most 59 bits of the key serial number initially injected into the PIN Entry Device along with the initial PIN encryption key during the "Load Initial Key" command. The contents of this register remain fixed for the service-life of the PIN Entry Device or until another "Load Initial Key" command.

Encryption Counter (21 bits)

A counter of the number of PIN encryptions that have occurred since the PIN Entry Device was first initialized. Certain counter values are skipped (as explained below), so that over 1 million PIN encryption operations are possible. Note: The concatenation (left to right) of the Initial Key Serial Number Register and the Encryption Counter form the 80-bit (20 hexadecimal digits) Key Serial Number Register.

Future Key Registers (21 registers of 34 hexadecimal digits each)

A set of 21 registers, numbered #1 to #21, used to store future PIN encryption keys. Each register includes a 2 hexadecimal digit longitudinal redundancy check (LRC) or a 2 hexadecimal digit cyclical redundancy check (CRC).

Temporary Registers

The following storage areas relating to key management are required on a temporary basis and may be used for other purposes by other PIN processing routines:

Current Key Pointer (approximately 4 hexadecimal digits)

Contains the address of that Future Key Register whose contents are being used in the current cryptographic operation. It identifies the contents of that Future Key Register whose address is contained in the Current Key Pointer.

Shift Register (21 bits)

A 21-bit register, whose bits are numbered left to right as #1 to #21. This register normally contains 20 "zero" bits and a single "one" bit. One use of this register is to select one of the Future Key Registers. The Future Key Register to be selected is the one numbered identically to the bit in the Shift Register containing the single "one".

Crypto Register-1 (16 hexadecimal digits)

A register used in performing cryptographic operations.

Crypto Register-2 (16 hexadecimal digits)

A second register used in performing cryptographic operations.

Key Register (32 hexadecimal digits)

A register used to hold a cryptographic key.

Algorithms

The Specifications can be downloaded from http://webstore.ansi.org/RecordDetail.aspx?sku=ANSI+X9.24-1%3A2009.

Practical Matters (KSN scheme)

In practical applications, one would have several BDKs on record, possibly for different customers, or to contain the scope of key compromise. When processing transactions, it is important for the receiver to know which BDK was used to initialize the originating device. To achieve this, the 80-bit KSN is structured into parts: as Key Set ID, a TRSM ID, and the transaction counter. The algorithm specifies that the transaction counter is 21-bits, but treats the remaining 59 bits opaquely (the algorithm only specifies that unused bits be 0-padded to a nibble boundary, and then 'f' padded to the 80-bit boundary). Because of this, the entity managing the creation of the DUKPT devices (typically a merchant acquirer) is free to subdivide the 59 bits according to their preference.

The industry practice is to designate the partitioning as a series of three digits, indicating the number of hex digits used in each part: the Key Set ID, the TRSM ID, and the transaction counter. A common choice is '6-5-5', meaning that the first 6 hex digits of the KSN indicate the Key Set ID (i.e., which BDK is to be used), the next 5 are the TRSM ID (i.e. a device serial number within the range being initialized via a common BDK), and the last 5 are the transaction counter.

This notational scheme is not strictly accurate, because the transaction counter is 21 bits, which is not an even multiple of 4 (the number of bits in a hex digit). Consequently, the transaction counter actually consumes one bit of the field that is the TRSM ID (in this example that means that the TRSM ID field can accommodate 2(5*4-1) devices, instead of 2(5*4), or about half a million).

Also, it is common practice in the industry to use only 64-bits of the KSN (probably for reasons pertinent to legacy systems, and DES encryption), which would imply that the full KSN is padded to the left with four ‘f’ hex digits. The remaining 4 hex digits (16-bits) are available, nonetheless, to systems which can accommodate them.

The 6-5-5 scheme mentioned above would permit about 16 million BDKs, 500,000 devices per BDK, and 1 million transactions per device.


Wikimedia Foundation. 2010.

Игры ⚽ Поможем сделать НИР

Look at other dictionaries:

  • DUKPT — Derived Unique Key Per Transaction (Computing » Security) …   Abbreviations dictionary

  • Shared secret — In cryptography, a shared secret is a piece of data only known to the parties involved in a secure communication. The shared secret can be a password, a passphrase, a big number or an array of randomly chosen bytes.The shared secret is either… …   Wikipedia

  • передаваемый уникальный ключ транзакции — Стандартная схема ключа транзакции (США). См. transaction key (ключ транзакции). [http://www.morepc.ru/dict/] Тематики информационные технологии в целом EN Derived Unique Key Per TransactionDUKPT …   Справочник технического переводчика

  • cryptology — cryptologist, n. cryptologic /krip tl oj ik/, cryptological, adj. /krip tol euh jee/, n. 1. cryptography. 2. the science and study of cryptanalysis and cryptography. [1635 45; < NL cryptologia. See CRYPTO , LOGY] * * * Introduction …   Universalium

  • Debit card — Personal finance Credit and debt Pawnbroker Student loan Employment contract Salary Wage Empl …   Wikipedia

  • Hawala — (also known as hundi) is an informal value transfer system based on performance and honor of a huge network of money brokers which are primarily located in the Middle East, Africa and Asia.OriginsHawala has its origins in classical Islamic law,… …   Wikipedia

  • Business and Industry Review — ▪ 1999 Introduction Overview        Annual Average Rates of Growth of Manufacturing Output, 1980 97, Table Pattern of Output, 1994 97, Table Index Numbers of Production, Employment, and Productivity in Manufacturing Industries, Table (For Annual… …   Universalium

  • china — /chuy neuh/, n. 1. a translucent ceramic material, biscuit fired at a high temperature, its glaze fired at a low temperature. 2. any porcelain ware. 3. plates, cups, saucers, etc., collectively. 4. figurines made of porcelain or ceramic material …   Universalium

  • China — /chuy neuh/, n. 1. People s Republic of, a country in E Asia. 1,221,591,778; 3,691,502 sq. mi. (9,560,990 sq. km). Cap.: Beijing. 2. Republic of. Also called Nationalist China. a republic consisting mainly of the island of Taiwan off the SE coast …   Universalium

  • Mathematics and Physical Sciences — ▪ 2003 Introduction Mathematics       Mathematics in 2002 was marked by two discoveries in number theory. The first may have practical implications; the second satisfied a 150 year old curiosity.       Computer scientist Manindra Agrawal of the… …   Universalium

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”