Rubidium-strontium dating

The rubidium-strontium dating method is a radiometric dating technique that geologists use to determine the age of rocks.

Development of this process was aided by Fritz Strassmann, who later moved onto discovering nuclear fission with Otto Hahn and Lise Meitner.

The utility of the rubidium-strontium isotope system results from the fact that ⁸⁷Rb decays to ⁸⁷Sr. Different minerals in a given geologic setting can have a distinctly different ratio of Strontium-87 to Strontium-86 (⁸⁷Sr/⁸⁶Sr) as a consequence of different ages, original Rb/Sr values and the initial ⁸⁷Sr/⁸⁶Sr.

If these minerals crystallized from the same silicic melt, each mineral had the same initial ⁸⁷Sr/⁸⁶Sr as the parent melt. However, because Rb substitutes for K in minerals and these minerals have different K/Ca ratios, the minerals will have had different Rb/Sr ratios.

During fractional crystallization, Sr tends to become concentrated in plagioclase, leaving Rb in the liquid phase. Hence, the Rb/Sr ratio in residual magma may increase over time, resulting in rocks with increasing Rb/Sr ratios with increasing differentiation. Highest ratios (10 or higher) occur in pegmatites.

Typically, Rb/Sr increases in the order plagioclase, hornblende, K-feldspar, biotite, muscovite. Therefore, given sufficient time for significant production (ingrowth) of radiogenic ⁸⁷Sr, measured ⁸⁷Sr/⁸⁶Sr values will be different in the minerals, increasing in the same order.

Example

For example, consider the case of an igneous rock such as a granite that contains several major Sr-bearing minerals including plagioclase feldspar, K-feldspar, hornblende, biotite, and muscovite. Each of these minerals has a different initial rubidium/strontium ratio dependent on their potassium content, the concentration of Rb and K in the melt and the temperature at which the minerals formed. Rubidium substitutes for potassium within the lattice of minerals at a rate proportional to its concentration within the melt.

The ideal scenario according to Bowen's reaction series would see a granite melt begin crystallizing a cumulate assemblage of plagioclase and hornblende (ie; tonalite or diorite), which is low in K (and hence Rb) but high in Sr (as this substitutes for Ca), which proportionally enriches the melt in K and Rb. This then causes orthoclase and biotite, both K rich minerals into which Rb can substitute, to precipitate. The resulting Rb-Sr ratios and Rb and Sr abundances of both the whole rocks and their component minerals will be markedly different. This, thus, allows a different rate of radiogenic Sr to evolve in the separate rocks and their component minerals as time progresses.

Calculating the age

The age of a sample is determined by analysing several minerals within the sample. The Sr87/Sr86 ratio for each sample is plotted against its Rb87/Sr86 ratio on a graph called an isochron. If these form a straight line then the samples are consistent, and the age probably reliable. The slope of the line dictates the age of the sample.

ources of error

Rb-Sr dating relies on correctly measuring the Rb-Sr ratio of a mineral or whole rock sample, plus accurately deriving an accurate ⁸⁷Sr/⁸⁶Sr ratio for the mineral or whole rock sample.

Several preconditions must be satisfied before a Rb-Sr date can be considered as representing the time of emplacement or formation of a rock.
* The system must have remained closed to Rb and Sr diffusion from the time at which the rock formed or fell below the blocking temperature (generally considered to be 650 °C);
* The minerals which are taken from a rock to construct an isochron must have formed in chemical equilibrium with one another or in the case of sediments, be deposited at the same time;
* The rock must not have undergone any metasomatism which could have disturbed the Rb-Sr system either thermally or chemically

One of the major drawbacks (and, conversely, the most important use) of utilizing Rb and Sr to derive a radiometric date is their relative mobility, especially in hydrothermal fluids. Rb and Sr are relatively mobile alkaline elements and as such are relatively easily moved around by the hot, often carbonated hydrothermal fluids present during metamorphism or magmatism.

Conversely, these fluids may metasomatically alter a rock, introducing new Rb and Sr into the rock (generally during potassic alteration or calcic (albitisation) alteration. Rb-Sr can then be used on the altered mineralogy to date the time of this alteration, but not the date at which the rock formed.

Thus, assigning "age significance" to a result requires studying the metasomatic and thermal history of the rock, any metamorphic events, and any evidence of fluid movement. A Rb-Sr date which is at variance with other geochronometers may not be useless, it may be providing data on an event which is not representing the age of formation of the rock.

Uses

Geochronology

The Rb-Sr dating method has been used extensively in dating rocks. If the initial amount of Sr is known or can be extrapolated, the age can be determined by measurement of the Rb and Sr concentrations and the ⁸⁷Sr/⁸⁶Sr ratio. The dates indicate the true age of the minerals only if the rocks have not been subsequently altered.

The important concept in isotopic tracing is that Sr derived from any mineral through weathering reactions will have the same ⁸⁷Sr/⁸⁶Sr as the mineral.

Isotope geochemistry

Initial ⁸⁷Sr/⁸⁶Sr ratios are a useful tool in archaeology, forensics and palaeontology because the ⁸⁷Sr/⁸⁶Sr of a skeleton, sea shell or indeed a clay artefact is directly comparable to the source rocks upon which it was formed or upon which the organism lived. Thus, by measuring the current-day ⁸⁷Sr/⁸⁶Sr ratio (and often the Nd-Nd ratios as well) the geological fingerprint of an object or skeleton can be measured, allowing migration patterns to be determined.

trontium isotope stratigraphy

Strontium isotope stratigraphy relies on recognised variations in the ⁸⁷Sr/⁸⁶Sr ratio of seawater over time. The application of Sr isotope stratigraphy is generally limited to carbonate samples for which the Sr seawater curve is well defined. This is well-known for the Cenozoic time-scale but, due to poorer preservation of carbonate sequences in the Mesozoic and earlier, it is not completely understood for older sequences.

In older sequences diagenetic alteration combined with greater uncertainties in estimating absolute ages due to lack of overlap between other geochronometers (for example U-Th) leads to greater uncertainties in the exact shape of the Sr isotope seawater curve.

References

* Jacobsen S.B., Wills J., Yin Q., 2000. "Seawater isotope records, crustal evolution, tectonics and atmospheric evolution". Proceedings, Seventh Annual V.M. Goldschmidt Conference, 2000. [http://www.lpi.usra.edu/meetings/gold/pdf/2392.pdf PDF abstract]
*USGS (2004) Resources on Isotopes:Strontium, http://wwwrcamnl.wr.usgs.gov/isoig/period/sr_iig.html Accessed February 20, 2006.

External links

* [http://www.dpr.csiro.au/ourcapabilities/petroleumgeoscience/inorganicgeochemistrygeochronology/projects/highresolutionpalaeozoicstrontiumisotopestratigraphy/ CSIRO Petroleum - Global Sr Seawater Isotope Evolution]