Runoff curve number

Runoff curve number

The runoff curve number (also called a curve number or simply CN) is an empirical parameter used in hydrology for predicting direct runoff or infiltration from rainfall excess.[1] The curve number method was developed by the USDA Natural Resources Conservation Service, which was formerly called the Soil Conservation Service or SCS — the number is still popularly known as a "SCS runoff curve number" in the literature. The runoff curve number was developed from an empirical analysis of runoff from small catchments and hillslope plots monitored by the USDA. It is widely used and is an efficient method for determining the approximate amount of direct runoff from a rainfall event in a particular area.

The runoff curve number is based on the area's hydrologic soil group, land use, treatment and hydrologic condition. References, such as from USDA[1] indicate the runoff curve numbers for characteristic land cover descriptions and a hydrologic soil group.

The runoff equation is

Q = \frac{(P-I_a)^2}{{P-I_a}+S}

where

Q is runoff ([L]; in)
P is rainfall ([L]; in)
S is the potential maximum soil moisture retention after runoff begins ([L]; in)
Ia is the initial abstraction ([L]; in), or the amount of water before runoff, such as infiltration, or rainfall interception by vegetation; and it is generally assumed that Ia = 0.2S

The runoff curve number, CN, is then related

S = \frac{1000}{CN} - 10

CN has a range from 30 to 100; lower numbers indicate low runoff potential while larger numbers are for increasing runoff potential. The lower the curve number, the more permeable the soil is.

Contents

Antecedent moisture condition (AMC) adjustment

Runoff is affected by the soil moisture before a precipitation event, or the antecedent moisture condition (AMC). A curve number, as calculated above, may also be termed AMC II or CNII, or average soil moisture. The other moisture conditions are dry, AMC I or CNI, and moist, AMC III or CNIII. The curve number can be adjusted by factors to CNII, where CNI factors are less than 1 (reduce CN and potential runoff), while CNIII factor are greater than 1 (increase CN and potential runoff). The AMC factors can be looked up in a reference table.[1]

References

  1. ^ a b c United States Department of Agriculture (1986). Urban hydrology for small watersheds. Technical Release 55 (TR-55) (Second Edition ed.). Natural Resources Conservation Service, Conservation Engineering Division. ftp://ftp.wcc.nrcs.usda.gov/downloads/hydrology_hydraulics/tr55/tr55.pdf. 

See also

External links


Wikimedia Foundation. 2010.

Игры ⚽ Поможем написать курсовую

Look at other dictionaries:

  • Surface runoff — Runoff flowing into a stormwater drain Surface runoff is the water flow that occurs when soil is infiltrated to full capacity and excess water from rain, meltwater, or other sources flows over the land. This is a major component of the water… …   Wikipedia

  • Runoff model (reservoir) — A runoff model is a mathematical model describing the rainfall runoff relations of a rainfall catchment area or watershed. More precisely, it produces the surface runoff hydrograph as a response to a rainfall hydrograph as input. In other words,… …   Wikipedia

  • Moselotte — The Moselotte flowing through Cornimont Mouth Moselle Basin countries …   Wikipedia

  • Infiltration (hydrology) — Infiltration is the process by which water on the ground surface enters the soil. Infiltration rate in soil science is a measure of the rate at which soil is able to absorb rainfall or irrigation. It is measured in inches per hour or millimeters… …   Wikipedia

  • Orne (Moselle) — For the river in Normandy, see Orne (river). Orne The Orne flooding at Rombas Origin Lorraine Mouth …   Wikipedia

  • Neuné — Near the La Chapelle sandpits Origin Gerbépal Mouth Vologne …   Wikipedia

  • Cleurie river — Cleurie Saut de la Cuve cascade on the Cleurie Origin Vosges Mountains Mouth Moselotte …   Wikipedia

  • Dranse (Haute-Savoie) — Dranse The Dranse de Morzine Mouth Lake Geneva Basin countries France …   Wikipedia

  • Hydrological modelling — Hydrologic models are simplified, conceptual representations of a part of the hydrologic cycle. They are primarily used for hydrologic prediction and for understanding hydrologic processes. Two major types of hydrologic models can be… …   Wikipedia

  • river — river1 riverless, adj. riverlike, adj. /riv euhr/, n. 1. a natural stream of water of fairly large size flowing in a definite course or channel or series of diverging and converging channels. 2. a similar stream of something other than water: a… …   Universalium

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”