- Ball-and-stick model
-
A plastic ball-and-stick model of a proline molecule
In chemistry, the ball-and-stick model is a molecular model of a chemical substance which is to display both the three-dimensional position of the atoms and the bonds between them. The atoms are typically represented by [[sphere (geometrysented by two or three curved rods, respectively. In a good model, the angles between the rods should be the same as the angles between the bonds, and the distances between the centers of the spheres should be proportional to the distances between the corresponding atomic nuclei. The chemical element of each atom is often indicated by the sphere's color.
In a ball-and-stick model, the radius of the spheres is usually much smaller than the rod lengths, in order to provide a clearer view of the atoms and bonds throughout the model. As a consequence, the model does not provide a clear insight about the space occupied by the model. In this aspect, ball-and-stick models are distinct from space-filling (Calotte) models, where the sphere radii are proportional to the atomic radii in the same scale as the atom distances, and therefore show the occupied space but not the bonds.
Computer ball-and-stick model of cyclohexane.Ball-and-stick models can be physical artifacts or virtual computer models. The former are usually built from molecular modeling kits, consisting of a number of helical springs or rods made of flexible plastic, and a number of plastic balls with pre-drilled holes. The sphere colors commonly follow the CPK coloring. Some university courses on chemistry require students to buy such models as learning material.
History
In 1865, German chemist August Wilhelm von Hofmann was the first to make stick-and-ball molecular models. He used such models in lecture at the Royal Institution of Great Britain.
Specialist companies manufacture kits and models to order. One of the earlier companies was Woosters at Bottisham, Cambridgeshire, UK. Besides tetrahedral, trigonal and octahedral holes, there were all-purpose balls with 24 holes. These models allowed rotation about the single rod bonds, which could be both an advantage (showing molecular flexibility) and a disadvantage (models are floppy). The approximate scale was 5 cm per ångström (0.5 m/nm or 500,000,000:1), but was not consistent over all elements.
The Beevers Miniature Models company in Edinburgh (now operating as Miramodus) produced small models using PMMA balls and stainless steel rods. In these models, the use of individually drilled balls with precise bond angles and bond lengths enabled large crystal structures to be accurately created in a light and rigid form. Figure 4 shows a unit cell of ruby in this style.
See also
Categories:
Wikimedia Foundation. 2010.
