Noise floor

Noise floor

In signal theory, the noise floor is the measure of the signal created from the sum of all the noise sources and unwanted signals within a measurement system, where the noise is defined as any signal other than the one being monitored.

In radio communication and electronics, this may include thermal noise, blackbody, cosmic noise as well as Atmospheric noise from distant thunderstorms and similar and any other unwanted man made signals, sometimes referred to as incidental noise . If the dominant noise is generated within the measuring equipment (for example by a receiver with a poor noise figure ) then this is an example of an instrumentation noise floor, as opposed to a physical noise floor . These terms are not always clearly defined, and are sometimes confused. [1]. Avoiding interference between electrical systems is the distinct subject of electromagnetic compatability EMC.

In a measurement system such as a seismograph, the physical noise floor may be set by the incidental noise, and include nearby foot traffic or a nearby road. The noise floor limits the smallest measurement that can be taken with certainty since any measured amplitude can on average be no less than the noise floor.

A common way to lower the noise floor in electronics systems is to cool the system to reduce thermal noise, when this is the major noise source. In special circumstances, the noise floor can also be artificially lowered with digital signal processing techniques.

Signals that are below the noise floor can be detected by using different techniques of spread spectrum communications, that effectively reduce the bandwidth of the signal.

Spectrum analyzer, display, noise floor.jpg

See also



Wikimedia Foundation. 2010.

Игры ⚽ Нужно сделать НИР?

Look at other dictionaries:

  • Noise Floor (Rarities 1998–2005) — Kompilationsalbum von Bright Eyes Veröffentlichung Oktober 2006 Label Saddle Creek …   Deutsch Wikipedia

  • Noise Floor (Rarities: 1998–2005) — Noise Floor (Rarities: 1998 2005) Compilation album by Bright Eyes Released …   Wikipedia

  • Noise shaping — is a technique typically used in digital audio, image, and video processing, usually in combination with dithering, as part of the process of quantization or bit depth reduction of a digital signal. Its purpose is to increase the apparent signal… …   Wikipedia

  • Noise figure — (NF) is a measure of degradation of the signal to noise ratio (SNR), caused by components in a radio frequency (RF) signal chain. The noise figure is defined as the ratio of the output noise power of a device to the portion thereof attributable… …   Wikipedia

  • Noise (audio) — Noise in audio, recording, and broadcast systems refers to the residual low level sound (usually hiss and hum) that is heard in quiet periods of a programme. In audio engineering, it can refer either to the acoustic noise from loudspeakers, or to …   Wikipedia

  • Noise measurement — is carried out in various fields. In acoustics, it can be for the purpose of measuring environmental noise, or part of a test procedure using white noise, or some other specialised form of test signal. In electronics it relates to the sensitivity …   Wikipedia

  • Noise (electronics) — Electronic noise [1] is a random fluctuation in an electrical signal, a characteristic of all electronic circuits. Noise generated by electronic devices varies greatly, as it can be produced by several different effects. Thermal noise is… …   Wikipedia

  • Noise — This article is about noise as an unwanted phenomenon. For other uses, see Noise (disambiguation). NASA researchers at Glenn Research Center conducting tests on aircraft engine noise in 1967 In common use, the word noise means any unwanted …   Wikipedia

  • Noise temperature — In electronics, noise temperature is one way of expressing the level of available noise power introduced by a component or source. The power spectral density of the noise is expressed in terms of the temperature (in kelvins) that would produce… …   Wikipedia

  • Noise reduction — For sound proofing, see soundproofing. For scientific aspects of noise reduction of machinery and products, see noise control. Noise reduction is the process of removing noise from a signal. All recording devices, both analogue or digital, have… …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”