NLGI Grade

NLGI Grade

NLGI Grade is a widely used classification for lubricating greases. It was established by the National Lubricating Grease Institute. Greases are classified in one of nine grades based on their consistency.

NLGI Grade alone is not sufficient for specifying the grease for a particular application but it is a useful qualitative measure. While the science of tribology is still developing, NLGI Grade, in combination with other test-based properties is the only method for determining the potential suitability of various greases for a specific application.

The nine grades are defined by a range of worked penetration test results. The NLGI grade for a specific grease is determined using two test apparatus. The first apparatus consists of a closed container and a piston-like plunger. The face of the plunger is perforated to allow grease to flow from one side of the plunger to another as the plunger is worked up and down. The test grease is inserted into the container and the plunger is stroked 60 times while the test apparatus and grease are maintained at a temperature of 25 °C.

Once worked, the grease is placed in a penetration test apparatus. This apparatus consists of a container, a specially-configured cone and a dial indicator. The container is filled with the grease and the top surface of the grease is smoothed over. The cone is placed so that its tip just touches the grease surface and a dial indicator is set to zero at this position. When the test starts the weight of the cone will cause it to penetrate into the grease. After a specific time interval the depth of penetration is measured.

The following table.[1] shows the NLGI grades and the worked penetration ranges:

NLGI Grade Worked penetration after

60 Strokes at 25 °C (0.1 mm)

Appearance Consistency food analog
000 445-475 fluid cooking oil
00 400-430 semi-fluid applesauce
0 355-385 very soft brown mustard
1 310-340 soft tomato paste
2 265-295 "normal" grease peanut butter
3 220-250 firm vegetable shortening
4 175-205 very firm frozen yogurt
5 130-160 hard smooth pate
6 85-115 very hard cheddar cheese

NLGI Grades 000 to 1 are used in application requirings low viscous friction. Examples include enclosed gear drives operating at low speeds and open gearing. Grades 0, 1 and 2 are used in highly loaded gearing. Grades 1 through 4 are often used in rolling contact bearings where grade 2 is the most common.

Grease Consistency — Lower numbers are softer and flow better, while higher numbers are firmer, tend to stay in place, and are a good choice when leakage is a concern. The table above compares the most common NLGI grades with household products that have similar consistencies.

References

  1. ^ Rudnick, Leslie R. (2005). Synthetics, Mineral Oils, and Bio-Based Lubricants: Chemistry and Technology (Chemical Industries). CRC. pp. 468. ISBN 1574447238. 

Wikimedia Foundation. 2010.

Игры ⚽ Нужен реферат?

Look at other dictionaries:

  • National Lubricating Grease Institute — The National Lubricating Grease Institute is an international trade association that serves the grease and gear lubricant industry. It exists to promote research and development of lubrication technology. It also publishes industry standards for… …   Wikipedia

  • Lubricant — A lubricant is a substance introduced to reduce friction between moving surfaces. It may also have the function of transporting foreign particles and of distributing heat. The property of reducing friction is known as lubricity. A good lubricant… …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”