# Groundwater energy balance

﻿
Groundwater energy balance

The groundwater energy balance is the energy balance of a groundwater body in terms of incoming hydraulic energy associated with groundwater inflow into the body, energy associated with the outflow, energy conversion into heat due to friction of flow, and the resulting change of energy status and groundwater level.

Theory

When multiplying the horizontal velocity of groundwater (dimension, for example, m3/day per m2 cross-sectional area) with the groundwater potential (dimension energy per m3 water, or "E"/m3) one obtains an energy flow (flux) in "E"/day per m2 cross-sectional area. [ R.J.Oosterbaan, J.Boonstra and K.V.G.K.Rao, 1996, The energy balance of groundwater flow. In: V.P.Singh and B.Kumar (eds.), Subsurface-Water Hydrology, p. 153-160. Kluwer academic publishers, The Netherlands. For free download see "external links". ]

Summation or integration of the energy flux in a vertical cross-section of unit width (say 1 m) from the lower flow boundary (the impermeable layer or base) up to the water table in an unconfined aquifer gives the energy flow "Fe" through the cross-section in "E"/day per m width of the aquifer.

While flowing, the groundwater loses energy due to friction of flow, i.e. hydraulic energy is converted into heat. At the same time, energy may be added with the recharge of water coming into the aquifer through the water table. Thus one can make an hydraulic energy balance of a block of soil between two nearby cross-sections. In steady state, i.e. without change in energy status and without accumulation or depletion of water stored in the soil body, the energy flow in the first section plus the energy added by groundwater recharge between the sections minus the energy flow in the second section must equal the energy loss due to friction of flow.

In mathematical terms this balance can be obtained by differentiating the cross-sectional integral of "Fe" in the direction of flow using the Leibnitz rule, taking into account that the level of the water table may change in the direction of flow.The mathematics is simplified using the Dupuit assumption.

The hydraulic friction losses can be described in analogy to Joule's law in electricity, where the friction losses are proportional to the square value of the current (flow) and the electrical resistance of the material through which the current occurs. In groundwater hydraulics (fluid dynamics, hydrodynamics) one often works with hydraulic conductivity (i.e. permeability of the soil for water), which is inversely proportional to the hydraulic resistance.

The resulting equation of the energy balance of groundwater flow can be used, for example, to calculate the shape of the water table under specific aquifer conditions. For this a numerical solution can be used, taking small steps along the impermeable base. The equation is to be solved by trial and error (iterations), because the hydraulic potential is taken with respect to a reference level for which we use the level of the water table at the water divide midway between the drains. When calculating the shape of the water table, its level at the water divide is initially not known. Therefore this level is to be assumed before the calculations on the shape of the water table can be started. According to the findings of the calculation procedure, the initial assumption is to be adjusted and the calculations are to be restarted until the level of the water table at the divide does not differ significantly from the assumed level.The trial and error procedure is cumbersome and therefore computer programs may be developed to aid in the calculations.

Application

The computer program EnDrain [ R.J.Oosterbaan, 1997, The energy balance of groundwater flow applied to subsurface drainage in anisotropic soils by pipes or ditches with entrance resistance. In this article, the confluence of flow (radial flow) towards the drain is taken into account. For free download see "external links". ] compares the outcome of the traditional drain spacing equation, based on Darcy's law cum continuity equation (i.e. conservation of mass), with the solution obtained by the energy balance and it can be seen that drain spacings are wider in the latter case. This is owing to the introduction of the energy supplied by the incoming recharge.

ee also

*Hydrogeology
*Groundwater discharge
*Groundwater flow equation

References

*The articles of references 1 and 2 can be viewed and downloaded freely from : [http://www.waterlog.info/articles.htm] .

Invitation

The reader is invited to apply the energy balance to the seepage surface along a sloping outlet boundary of an aquifer, at the foot of a river embankment, or at the end of a water conduit from which the water falls down, and improve and expand this article.

Wikimedia Foundation. 2010.

### Look at other dictionaries:

• Energy balance — has the following meanings in several fields:* In physics, energy balance is a systematic presentation of energy flows and transformations in a system. Theoretical basis for an energy balance is the first law of thermodynamics according to which… …   Wikipedia

• Groundwater model — Groundwater models are computer models of groundwater flow systems, and are used by hydrogeologists. Groundwater models are used to simulate and predict aquifer conditions.CharacteristicsAn unambiguous definition of groundwater model is difficult …   Wikipedia

• Groundwater discharge — is the volumetric flow rate of groundwater through an aquifer. Groundwater discharge, Q Total groundwater discharge, as reported through a specified area, is similarly expressed as::Q = frac{dh}{dl}KAwhere: Q is the total groundwater discharge (… …   Wikipedia

• Groundwater flow equation — Used in hydrogeology, the groundwater flow equation is the mathematical relationship which is used to describe the flow of groundwater through an aquifer. The transient flow of groundwater is described by a form of the diffusion equation, similar …   Wikipedia

• Conservation of energy — This article is about the law of conservation of GPE in physics. For sustainable energy resources, see Energy conservation. Prof. Walter Lewin demonstrates the conservation of mechanical energy, touching a wrecking ball with his jaw. (MIT Course… …   Wikipedia

• Solar energy — is the light and radiant heat from the Sun that powers Earth s climate and weather and sustains life. Since ancient times it has been harnessed for human use through a range of technologies. Solar radiation along with secondary solar resources… …   Wikipedia

• Drainage equation — A drainage equation is an equation describing the relation between depth and spacing of parallel subsurface drains, depth of the watertable, depth and hydraulic conductivity of the soils. It is used in drainage design. Parameters in Hooghoudt s… …   Wikipedia

• Watertable control — is the practice of controlling the water table in agricultural land by subsurface drainage with proper criteria to improve the crop production. Contents 1 Description and definitions 1.1 Purpose 1.2 Optimization 1.3 …   Wikipedia

• Hydrogeology — ( hydro meaning water, and geology meaning the study of the Earth) is the area of geology that deals with the distribution and movement of groundwater in the soil and rocks of the Earth s crust, (commonly in aquifers). The term geohydrology is… …   Wikipedia

• Well drainage — means drainage of agricultural lands by wells. Agricultural land is drained by pumped wells (vertical drainage) to improve the soils by controlling water table levels and soil salinity. Contents 1 Introduction 2 Design 3 Flow to wells 4 …   Wikipedia