Active layer

Active layer

In environments containing permafrost, the active layer is the top layer of soil that thaws during the summer and freezes again during the autumn. In all climates, whether they contain permafrost or not, the temperature in the lower levels of the soil will remain more stable than that at the surface, where the influence of the ambient temperature is greatest. This means that, over many years, the influence of cooling in winter and heating in summer (in temperate climates) will decrease as depth increases. [citebook|title=Fundamentals of Geomorphology |author= Richard John Huggett|year=2003|publisher=Routledge|id=ISBN 0415241456|pages=237]

If the winter temperature is below the freezing point of water, a frost front will form in the soil. This "frost front" is the boundary between frozen and unfrozen soil, and with the coming of spring and summer, the soil is thawed, "always from the top down". If the heating during summer exceeds the cooling during winter, the soil will be completely thawed during the summer and there will be no permafrost. This occurs when the mean annual temperature is above 0°C (32°F), but also occurs when the mean annual temperature is slightly below 0°C on sites exposed to the sun with coarse-textured parent materials.

When there is not sufficient heat to thaw the frozen soil completely, permafrost forms. The active layer in this environment consists of the top layers of soil which thaws during the summer, whilst the inactive layer refers to the soil below which is frozen year-round because the heat fails to penetrate. Liquid water cannot flow below the active layer, with the result that permafrost environments tend to be very poorly drained and boggy.

Thaw depth

The thickness of the active layer, known as the thaw depth, is determined by how far the frost front is forced to retreat due to heating during the summer.

Thus, the primary determinant of active layer thickness is the maximum temperature attained during the summer. If it is only a little above 0°C, the active layer can be very thin (only 10 cm on Ellesmere Island), whilst if it is quite warm, it is much thicker (about 2.5 m at Yakutsk), and if the permafrost is discontinuous and soil begins thawing earlier, it can be still thicker (5 meters at Yellowknife). The parent material of the soil is also important: active layers in soils made of sandy or gravelly parent materials can be up to five times deeper than those made from loam- or clay-rich parent material. This is because the coarser material allows for much greater conductivity of heat down into the soil.

This is important because roots of plants cannot penetrate beyond the active layer and are restricted by its thickness. Thus, in a continuous permafrost environment plants must have shallow roots, which restricts tree growth to specialised species such as "Larix". In areas of discontinuous permafrost, most conifers are able to grow easily.

Pereletok

Because of variation in summer temperatures from year to year, the amount of heating of the active layer also varies - hence the depth of thaw is not constant. Soil that will thaw only during a hotter-than-average summer is known as Pereletok (a Russian word meaning "old ice". It can also be referred to as an Intergelisol.

oil formation in the active layer

Cryoturbation is the dominant force operating in the active layer, and tends to make it generally uniform in composition throughout. However, variation in the composition of soils due to differences in parent rock are very marked in permafrost regions due to the low rate of weathering in the very cold climate.

The slow rate of decomposition of organic material means Gelisols (permafrost soils) are very important as a sink for carbon dioxide. This carbon dioxide and other greenhouse gases (chiefly methane) forms from the very slow decomposition of the excess organic matter that remains in most Gelisols and is mixed down into the pereletok layer during relatively hot summers and below that layer during warmer periods about 5000 to 6000 years ago. This storage of carbon means thawing of permafrost may accelerate global warming - some suggest the difference could become very significant especially if the carbon has been stored since "before" recent glacial maxima.

See also

References


Wikimedia Foundation. 2010.

Игры ⚽ Поможем написать курсовую

Look at other dictionaries:

  • active layer — (in arctic or subarctic regions) the layer of soil, above the permafrost, that thaws during the summer. * * * …   Universalium

  • active layer —   the upper few metres of soil in a periglacial area which undergoes thawing in summer and is prone to mass movement relative to the permafrost layer below …   Geography glossary

  • active layer —    The top layer of ground subject to annual thawing and freezing in areas underlain by permafrost.    NRC …   Glossary of landform and geologic terms

  • active layer — (in arctic or subarctic regions) the layer of soil, above the permafrost, that thaws during the summer …   Useful english dictionary

  • Active pixel sensor — An active pixel sensor (APS) is an image sensor consisting of an integrated circuit containing an array of pixel sensors, each pixel containing a photodetector and an active amplifier. There are many types of active pixel sensors including the… …   Wikipedia

  • Layer 2 Tunneling Protocol — In computer networking, the Layer 2 Tunneling Protocol (L2TP) is a tunneling protocol used to support virtual private networks (VPNs). History and future Published in 1999 as proposed standard RFC 2661, L2TP has its origins primarily in two older …   Wikipedia

  • Layer 2 Tunneling Protocol — L2TP im TCP/IP‑Protokollstapel: Anwendung L2TP Transport UDP Internet IP (IPv4, IPv6) Netzzugang Ethernet Token …   Deutsch Wikipedia

  • Layer Two Tunneling Protocol — L2TP im TCP/IP‑Protokollstapel: Anwendung L2TP Transport UDP Internet IP (IPv4, IPv6) Netzzugang Ethernet Token …   Deutsch Wikipedia

  • Active Format Description — In television technology, Active Format Description (AFD) is a standard set of codes that can be sent in the MPEG video stream or in the baseband SDI video signal that carries information about their aspect ratio and active picture… …   Wikipedia

  • Active Denial System — Humvee with ADS mounted The Active Denial System (ADS) is a non lethal, directed energy weapon developed by the U.S. military.[1] It is a strong millimeter wave transmitter primarily used for crowd control (the goodbye effect [ …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”