Quad antenna

Quad antenna
patent US2537191
A quad antenna.

The quad antenna is an antenna which is frequently used by amateur radio operators. It consists of a driven element and parasitic elements, like a Yagi; however, the elements are square loops. If there is only one parasitic element it is referred to as a 'Cubical Quad' (since it will be an approximate cube).

Contents

History

It was developed by Clarence C. Moore (patent no. 2,537,191), W9LZX, an engineer at HCJB (a shortwave missionary radio station high in the Andean Mountains). He developed it to resolve issues with large coronal discharges in the thin air with a beam antenna.

Moore describes his antenna as "a pulled-open folded dipole" and describes the time when it was developed:

We took about one hundred pounds of engineering reference books with us on our short vacation to Posoraja, Ecuador during the summer of 1942, determined that with the help of God we could solve our problem. There on the floor of our bamboo cottage we spread open all the reference books we had brought with us and worked for hours on basic antenna design. Our prayers must have been answered, for gradually as we worked the vision of a quad-shaped antenna gradually grew with the new concept of a loop antenna having no ends to the elements, and combining relatively high transmitting impedance and high gain.

Moore's design eliminated coronal discharge. "End effect", which is inherent with the Yagi, is absent in a quad because its elements have no ends. But other advantages appeared. The higher impedance, mentioned in the quote above, translates to lower current and thus lower loss on the transmission lines. And gain was found to be higher than that of a Yagi.

Advantages over a Yagi-Uda

Rigorous testing of the quad antenna, reported in William Orr's authoritative "All About Cubical Quad Antennas", and others, have illustrated the following advantages over a Yagi-Uda antenna.

Higher Gain

The 2-element Quad has almost the same gain as a 3-element Yagi-Uda: about 7.5 dB over a dipole. Likewise, a 3-element Quad has more gain than a 3-element Yagi-Uda. However, adding quad elements produces diminishing returns. Quoting from William Orr, "Whereas parasitic beams having twenty or thirty parasitic directors are efficient, high gain antennas, it would seem... that maximum practical number of parasitic loop elements for the Quad array is limited to four or five." (Orr, Pg. 48)

Radiation Resistance approximately 50Ω

Radiation resistance is affected by antenna height above ground, element spacing, and environmental conditions. However, values will be higher than Yagi's and more closely matched to a 50 Ω coaxial feed

Lower Boom Height

"A two-element, three-band quad, with elements mounted only 35 feet above ground, will give good performance in situations where a triband Yagi will not." (Page 12-3 of the 15th edition of The ARRL Antenna Book.)

Shorter Boom

William Orr's book shows a 10-15-20 meter, 2-element Quad with boom length of 6'10".

May be Internally Stacked to form Multi-Band Arrays

As Orr states, interaction between antennas of a multi-band Quad are quite low, even when fed with a single feed line. (Orr, Pg. 63)

Lower Angle Radiation

According to K0SR, (pg. 5 of the ARRL's Jan/Feb 2008 National Contest Journal) the claim that quads "open the band earlier", which suggests that they exhibit a lower angle of radiation than Yagis, has persisted for 50 years in spite of the fact that computer models disagree. He posits that the vertical sides of each element actually radiate the low angle component.

Broader Bandwidth

The bandwidth for a 3-element Quad antenna that is tuned for maximum gain is limited because excursions from the design frequency unbalance the near resonance condition of the parasitic elements. However, by lengthening the reflector and director elements, thus sacrificing approximately 1 dB gain, the entire 10 meter band may be worked with an SWR below 1.75:1.

Quieter to RF Noise

This is an unsubstantiated, subjective note.

The E-Z-O variation

3-Element E-Z-O Antenna Prototype

An improvement over the Quad design has been claimed by N8PPQ. In 2008 he introduced the E-Z-O antenna which uses flexible dielectric tubes, rather than rigid poles, to support the electrical elements. He claims slightly higher gain over the Quad due to its circular form; circles being the shape that the Quad only roughly approximates. Here is his list of reported improvements over the Quad antenna:

  • Lower Cost
  • Higher Gain
  • Lighter in Weight
  • Less Wind/Ice Loading
  • Easier to Install and Maintain
  • Aesthetically Pleasing

The magnitude of the dielectric effect on the outside band elements was surprising. Experimentation was required to establish optimum element lengths. Referencing literature was not to be found. As reported at http://personal.ee.surrey.ac.uk/Personal/D.Jefferies/antennexarticles/diecon.htm, "As far as we are aware, there has been no reported work on encasing loop antennas in dielectric." It appears that "near field" interaction between parallel components increases the magnitude of the dielectric effect. Near field analysis is too complicated for this author.

Patents

References

External links


Wikimedia Foundation. 2010.

Игры ⚽ Поможем написать курсовую

Look at other dictionaries:

  • Antenna (radio) — Whip antenna on car …   Wikipedia

  • Microstrip antenna — In telecommunication, there are several types of microstrip antennas (also known as printed antennas) the most common of which is the microstrip patch antenna or patch antenna. A patch antenna is a narrowband, wide beam antenna fabricated by… …   Wikipedia

  • Loop antenna — A shortwave loop antenna A loop antenna is a radio antenna consisting of a loop (or loops) of wire, tubing, or other electrical conductor with its ends connected to a balanced transmission line. Within this physical description there are two very …   Wikipedia

  • Dipole antenna — A schematic of a half wave dipole antenna connected to an unbalanced coaxial cable. Better practice is to connect the balanced dipole to the unbalanced line with a balun. A dipole antenna is a radio antenna that can be made of a simple wire, with …   Wikipedia

  • Parabolic antenna — A parabolic satellite communications antenna at Erdfunkstelle Raisting, the biggest facility for satellite communication in the world, in Raisting, Bavaria, Germany. It has a Cassegrain type feed. A parabolic antenna is an antenna that uses a… …   Wikipedia

  • Discone antenna — Mounted discone antenna designed for VHF and UHF coverage …   Wikipedia

  • Monopole antenna — Mast radiator monopole antenna used for broadcasting. AM radio station WARE, Warren, Massachusetts, USA. A monopole antenna is a class of radio antenna consisting of a straight rod shaped conductor, often mounted perpendicularly over some type of …   Wikipedia

  • Rubber Ducky antenna — on a transceiver The Rubber Ducky antenna (or Rubber Duck aerial) is an electrically short monopole antenna which functions somewhat like a base loaded whip antenna and is sealed in a rubber or plastic jacket to protect the antenna.[1]… …   Wikipedia

  • HRS antenna — HRS type antennas are more or less the standard antenna used for long distance high power shortwave broadcasting (> 1000 km). Contents 1 History of HRS design 2 Nomenclature 3 A versatile antenna type …   Wikipedia

  • Horn antenna — Pyramidal microwave horn antenna, with a bandwidth of 0.8 to 18 GHz. A coaxial cable feedline attaches to the connector visible at top. This type is called a ridged horn; the curving fins visible inside the mouth of the horn increase the antenna… …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”