Decay correct

Decay correct

Decay correct is a method of adjusting the measurements of radioactive decay obtained at two different time points so that they may be used as a single data set. If a chemical compound is tagged with a radioactive isotope then the amount of radiation released in a period of time is proportional to the number of atoms of the isotope; but as time passes some of the isotope decays and the isotope remaining (which is measured by the radiation) is no longer the same as the amount of compound present. Decay correction is a mathematical method of determining the amount of compound present given the amount of isotope remaining.

Use

For example, in biodistribution studies, it is common to track the movement of a compound of interest through an animal. To measure the compound it is chemically joined to a radionuclide. Thus the energy measured from the radioactive decay is related to the quantity of the compound of interest.

Samples may be collected and counted at short time intervals (ex: 1 and 4 hours). The next samples (from another set of animals injected at the same starting time) may not be collected and counted until 24, 48, or 72 hours. Because isotopes for therapy and imaging often have a relatively short half-life (under 10 days), it is necessary to adjust the data in order to compare all the time points.

For example, the isotope copper-64, commonly used in medical research, has a half-life of 12.7 hours. If you inject a large group of animals at "time zero", but measure the radioactivity in their organs at two later times, the later groups must be "decay corrected" to adjust for the decay that has occurred between the two time points.

Mathematics

The formula for decay correcting is: A_0 = \left ( {A_t}*{e^{kt}} \right )

where At is the raw, (uncorrected) count at time t, A0 is the count at time 0 (the decay corrected counts), "e" is the "inverse natural log" function, "k" is the decay constant (or "lambda"), and "t" is the elapsed time.

The decay constant is \left ( \frac{0.693}{t_{1/2}} \right ) where .693 is (approximately) the ln2 and "t1 / 2" is the half-life of the radioactive material of interest.

Example

The decay correct might be used this way: a group of 20 animals is injected with a compound of interest on a Monday at 10:00 a.m. The compound is chemically joined to the isotope copper-64, which has a known half-life of 12.7 hours, or 764 minutes. After one hour, the 5 animals in the "one hour" group are killed, dissected, and organs of interest are placed in sealed containers to await measurement. This is repeated for another 5 animals, at 2 hours, and again at 4 hours. At this point, (say, 4:00 p.m., Monday) all the organs collected so far are measured for radioactivity (a proxy of the distribution of the compound of interest). The next day (Tuesday), the "24 hour" group would be killed and dissected at 10:00 a.m., then measured for radioactivity, (say at 11:00 a.m.). In order to compare ALL the groups together, the data from the "24 hour" must be decay corrected: the radioactivity measured on the second day must be "adjusted" in order to allow a comparison to measurements from an earlier time, but of the same original material.

In this case, "time zero" is Monday, 4:00 p.m., when the first three groups (1,2, and 4 hour animals organs) were measured. The "24 hour" group was measured at 11:00 a.m. Tuesday, which is 19 hours after the first groups.

Start by calculating the decay constant "K". Substitute 12.7 (hours, the half-life of copper-64) for t1 / 2, giving  {0.693 \over 12.7} = 0.0546.

Next, multiply this value of "K" by the time elapsed between the first and second measures of radioactivity, 19 hours: (0.0546 x 19) = 1.0368.

Change the sign, to make it -1.0368, then find the "inverse Ln"; in this case 0.3546.

This value is in the denominator of the decay correcting fraction, so it is the same as multiplying the numerator by its inverse ( {1 \over 0.3546} ), which is 2.82.

(A simple way to check if you are using the decay correct formula right is to put in the value of the half-life in place of "t". After you perform the inverse Ln, the value should be very close to 0.5. When divided into the value "A" (for uncorrected counts), it effectively doubles them, which is the necessary correction after one half-life has occurred.)

In this case, the uncorrected values will be multiplied by 2.82, which corrects for 19 hours elapsing (between one and two half-lives).

If the radiation measured has dropped by half between the 4 hour sample and the 24 hour sample we might think that the concentration of compound in that organ has dropped by half; but applying the decay correct we see that the concentration is 0.5*2.82 so it has actually increased by 40% in that period.


Wikimedia Foundation. 2010.

Игры ⚽ Поможем написать реферат

Look at other dictionaries:

  • C-decay — refers to a Young Earth Creationist proposal that the speed of light was over a million times faster within the last 10,000 years, immediately following the creation of the universe, and has been slowing down since then in a logarithmic decay. By …   Wikipedia

  • Automatic calculation of particle interaction or decay — The automatic calculation of particle interaction or decay is part of the computational particle physics branch. It refers to computing tools that help calculating the complex particle interactions as studied in high energy physics, astroparticle …   Wikipedia

  • subatomic particle — or elementary particle Any of various self contained units of matter or energy. Discovery of the electron in 1897 and of the atomic nucleus in 1911 established that the atom is actually a composite of a cloud of electrons surrounding a tiny but… …   Universalium

  • Mathematics and Physical Sciences — ▪ 2003 Introduction Mathematics       Mathematics in 2002 was marked by two discoveries in number theory. The first may have practical implications; the second satisfied a 150 year old curiosity.       Computer scientist Manindra Agrawal of the… …   Universalium

  • cosmos — /koz meuhs, mohs/, n., pl. cosmos, cosmoses for 2, 4. 1. the world or universe regarded as an orderly, harmonious system. 2. a complete, orderly, harmonious system. 3. order; harmony. 4. any composite plant of the genus Cosmos, of tropical… …   Universalium

  • quantum mechanics — quantum mechanical, adj. Physics. a theory of the mechanics of atoms, molecules, and other physical systems that are subject to the uncertainty principle. Abbr.: QM Cf. nonrelativistic quantum mechanics, relativistic quantum mechanics. [1920 25]… …   Universalium

  • Nobel Prizes — ▪ 2009 Introduction Prize for Peace       The 2008 Nobel Prize for Peace was awarded to Martti Ahtisaari, former president (1994–2000) of Finland, for his work over more than 30 years in settling international disputes, many involving ethnic,… …   Universalium

  • Mass–energy equivalence — E=MC2 redirects here. For other uses, see E=MC2 (disambiguation). 4 meter tall sculpture of Einstein s 1905 E = mc2 formula at the 2006 Walk of Ideas, Berlin, Germany In physics, mass–energy equivalence is the concept that the …   Wikipedia

  • United Kingdom — a kingdom in NW Europe, consisting of Great Britain and Northern Ireland: formerly comprising Great Britain and Ireland 1801 1922. 58,610,182; 94,242 sq. mi. (244,100 sq. km). Cap.: London. Abbr.: U.K. Official name, United Kingdom of Great… …   Universalium

  • Europe, history of — Introduction       history of European peoples and cultures from prehistoric times to the present. Europe is a more ambiguous term than most geographic expressions. Its etymology is doubtful, as is the physical extent of the area it designates.… …   Universalium

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”